EasyManua.ls Logo

Digi IX30

Digi IX30
1031 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Interfaces Wide Area Networks (WANs)
IX30 User Guide
81
(config network interface my_wan> ipv4 surelink enable true
(config network interface my_wan)>
5. By default, the device is configured to restart the interface when its connection is considered
to have failed.
To disable:
(config network interface my_wan ipv4 surelink)> restart false
(config network interface my_wan ipv4 surelink>
n
(Optional) Set the number of times that the Surelink test must fail before the interface
is restarted:
(config network interface my_wan ipv4 surelink)> restart_attempts
int
(config network interface my_wan ipv4 surelink>
where int is any number greater than 0. The default is 1.
6. (Optional) If the interface is a WWAN, by default, the device is configured to reset the modem
when its connection is considered to have failed.
To disable:
(config network interface my_wan ipv4 surelink)> reset_modem false
(config network interface my_wan ipv4 surelink>
7.
n
If reset_modem is enabled, set the number of times that Surelink tests must fail prior
to resetting the modem:
(config network interface my_wan ipv4 surelink)> reset_modem_
attempts int
(config network interface my_wan ipv4 surelink>
where int is an integer between 1 through 5. The default is 3.
If the interface is a WWAN, SIM switching is enabled by default. To disable:
(config network interface my_wan ipv4 surelink)> switch_sim false
(config network interface my_wan ipv4 surelink>
Note The SureLink switch_sim option differs from the sim_failover option, which is set
during WWAN configuration. sim_failover applies when the modem is unable to connect to a
cellular network, whereas switch_sim applies when the WWANinterface is failing SureLink
tests even though the modem is connected. See Configure a Wireless Wide Area Network
(WWAN) for more information about the sim_failover option.
n
If switch_sim is enabled, set the number of times that Surelink tests must fail prior to
switching SIMS:
(config network interface my_wan ipv4 surelink)> switch_sim_attempts
int
(config network interface my_wan ipv4 surelink>

Table of Contents

Related product manuals