S M - 5 3 0 0 S e r v i c e M a n u a l
S M - 5 3 0 0 S e r v i c e M a n u a l || 4141
Initial SetupInitial Setup
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
5.5 Software Setup
5.5 Software Setup
5.5 Software Setup5.5 Software Setup
5.5.1 Default Country SPEC5.5.1 Default Country SPEC
Note: Ensure the Span Switch is set toNote: Ensure the Span Switch is set to
[Enable][Enable]
..
Procedure PictureProcedure Picture
1) 1) In In Registration Registration mode, mode, press press and and follow follow byby
key button to MENUkey button to MENU
[MAINTENANCE][MAINTENANCE]
[MAINTENANCE][MAINTENANCE]
[SERVICE ADVANCE][SERVICE ADVANCE]
to go toto go to
Service Advance mode.Service Advance mode.
2) Keying the Password and select2) Keying the Password and select [ENTER][ENTER]button.button.
Password:Password:
09530953
3) Select3) Select [DEFAULT DATA][DEFAULT DATA]..
4) In DEFAULT SPEC mode,4) In DEFAULT SPEC mode,
select [LOAD FACTORYselect [LOAD FACTORY
DEFAULT]DEFAULT]..
To Next Page
Loading...
Need help?
General
