S M - 5 3 0 0 S e r v i c e M a n u a l
S M - 5 3 0 0 S e r v i c e M a n u a l || 99
Safety RegulationSafety Regulation
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Safety Regulations
Safety Regulations
Federal Communication Commission Interference StatementFederal Communication Commission Interference Statement
This equipment has been tested and found to This equipment has been tested and found to comply with the limits for comply with the limits for a Class B digital a Class B digital device,device,
pursuant to Part 15 of pursuant to Part 15 of the FCC Rules. These limits are the FCC Rules. These limits are designed to provide reasonable protectiondesigned to provide reasonable protection
against harmful interference in a against harmful interference in a residential installation. This equipment generates uses and can radiateresidential installation. This equipment generates uses and can radiate
radio frequency energy and, if not iradio frequency energy and, if not installed and used in accordance with the nstalled and used in accordance with the instructions, may causeinstructions, may cause
harmful interferencharmful interference to radio communications. e to radio communications. However, there is no guaHowever, there is no guarantee that interference willrantee that interference will
not occur in a particular installation. not occur in a particular installation. If this equipmenIf this equipment does cause harmful interferenct does cause harmful interference to radio ore to radio or
television reception, which can be determined by turning the television reception, which can be determined by turning the equipment off and on, the user equipment off and on, the user isis
encouraged to try to correct the encouraged to try to correct the interference by one of tinterference by one of the following measures:he following measures:
- Reorient or relocate the receiving antenna.- Reorient or relocate the receiving antenna.
- Increase the separation between the - Increase the separation between the equipment and receiver.equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.connected.
- Consult the dealer - Consult the dealer or an experienced radio/TV technician for help.or an experienced radio/TV technician for help.
This device complies with Part 15 This device complies with Part 15 of the FCC Rules. Operation iof the FCC Rules. Operation is subject to the following twos subject to the following two
conditions: (1) This device may not cause conditions: (1) This device may not cause harmful interference, and (2) this device harmful interference, and (2) this device must accept anymust accept any
interference received, including interference that interference received, including interference that may cause undesired operation.may cause undesired operation.
FCC Caution:FCC Caution:
Any changes or modifications not expressly approved by the party responsible forAny changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this compliance could void the user's authority to operate this equipment.equipment.
IMPORTANT NOTE:IMPORTANT NOTE:
FCC Radiation Exposure Statement:FCC Radiation Exposure Statement:
This equipment complies with FCC RF radiation exposure limits set forth This equipment complies with FCC RF radiation exposure limits set forth for a portable uncontrolledfor a portable uncontrolled
environment. To maintain compliance with FCC environment. To maintain compliance with FCC RF exposure compliance requirements:RF exposure compliance requirements:
1) Please do not 1) Please do not attach any decorative components with metal parts to this attach any decorative components with metal parts to this equipment.equipment.
2) The antenna must not be co-located or operating in conjunction with any other antenna or2) The antenna must not be co-located or operating in conjunction with any other antenna or
transmitter.transmitter.
FCC Radiation Exposure Statement: (Canada)FCC Radiation Exposure Statement: (Canada)
This equipment complies with FCC RF radiation exposure limits set forth This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolledfor an uncontrolled
environment. To comply with FCC environment. To comply with FCC RF exposure compliance requirements:RF exposure compliance requirements:
1) The antenna used 1) The antenna used for this transmitter must be for this transmitter must be installed and operated with minimum 20cm betweeninstalled and operated with minimum 20cm between
the antenna and users.the antenna and users.
2) The antenna must 2) The antenna must not be co-located or operating in not be co-located or operating in conjunction with any other antenna orconjunction with any other antenna or
transmitter.transmitter.
To Next Page
Loading...
