Digi SM-5300 - Hardware Component Testing

S M - 5 3 0 0 S e r v i c e M a n u a lS M - 5 3 0 0 S e r v i c e M a n u a l || 8989


S M 5 3 0 0 S e r v i c e M a n u a l
S M 5 3 0 0 S e r v i c e M a n u a l || 9090
Hardware Test And MaintenanceHardware Test And Maintenance
––––––––––––––––––––––––––––––––––––––
7.4 Hardware Test
7.4 Hardware Test
7.4 Hardware Test7.4 Hardware Test
7.4.1 Input7.4.1 Input

Procedure PictureProcedure Picture
1) 1) In In Registration Registration mode, mode, press press and and follow follow byby
key button go to MENUkey button go to MENU[MAINTENANCE][MAINTENANCE]
[MAINTENANCE][MAINTENANCE]

[HARDWARE TEST][HARDWARE TEST]
to go toto go to
Hardware Test menu.Hardware Test menu.
2) At Hardware Test 2) At Hardware Test menu, touchmenu, touch
[INPUT][INPUT]
then pressthen press
scale key button, scan barcode or scale key button, scan barcode or slide the magneticslide the magnetic
card.card.
3) The screen will show the value (Value may 3) The screen will show the value (Value may differentdifferent
depend on different data input). If depend on different data input). If not any response onnot any response on
the screen that mean the input test fail.the screen that mean the input test fail.