S M - 5 3 0 0 S e r v i c e M a n u a l
S M - 5 3 0 0 S e r v i c e M a n u a l || 66
Safety InformationSafety Information
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Safety Information
Safety Information
The operator of the The operator of the equipment shall comply with the safety and equipment shall comply with the safety and warning indications and procedureswarning indications and procedures
outlined in this document. Teraoka Weigh-System Pte. Ltd. assumes no responsibility or liability foroutlined in this document. Teraoka Weigh-System Pte. Ltd. assumes no responsibility or liability for
failure to comply with these requirements.failure to comply with these requirements.
To avoid electric shock, use only the supplied power cords and ensure product is connected to aTo avoid electric shock, use only the supplied power cords and ensure product is connected to a
properly grounded supply.properly grounded supply.
Ensure product is placed on a Ensure product is placed on a firm and level firm and level surface before operation.surface before operation.
Avoid overloadinAvoid overloading the producg the product beyond its rated mt beyond its rated maximum capacaximum capacity.ity.
Care shall be Care shall be taken during the following operationstaken during the following operations
oo
Receipt paper tearingReceipt paper tearing––to prevent injuries from cutting from paper cutterto prevent injuries from cutting from paper cutter
oo
Changing of labels and receipt paper Changing of labels and receipt paper - to prevent injuries - to prevent injuries from cutting from paper cutterfrom cutting from paper cutter
and movable printer and movable printer mechanism.mechanism.
Repair and servicing of product, shall Repair and servicing of product, shall only be carried out only be carried out by trained and qualified personnel.by trained and qualified personnel.
Disclaimer:Disclaimer:
Specifications are subject to change without notice. All dimensions shown are approximate. Please beSpecifications are subject to change without notice. All dimensions shown are approximate. Please be
aware that Teraoka Weigh-System Pte. Ltd. has indicated that aware that Teraoka Weigh-System Pte. Ltd. has indicated that its hardware and software used in its hardware and software used in thethe
product may require additional updates in the product may require additional updates in the future as our product is future as our product is continually under developmencontinually under development.t.
The need for such The need for such updates most likely applies to the Printer updates most likely applies to the Printer software.software.
CAUTIONS:CAUTIONS:
FOR PLUGGABLE EQUIPMENT, THAT THE SOCKET-OUTLET SHALL BE INSTALLED NEARFOR PLUGGABLE EQUIPMENT, THAT THE SOCKET-OUTLET SHALL BE INSTALLED NEAR
THE EQUIPMENT AND SHALL BE EASILY ACCESSIBLE.THE EQUIPMENT AND SHALL BE EASILY ACCESSIBLE.
POUR LE MATÉRIEL RACCORDÉ PAR PRISE DE POUR LE MATÉRIEL RACCORDÉ PAR PRISE DE COURANT, LE SOCLE DE PRISE DECOURANT, LE SOCLE DE PRISE DE
COURANT DOIT ÊTRECOURANT DOIT ÊTRE
INSALLÉ À PROXIMITÉ DU MATÉRIEL ET DOIT ÊTRE AISÉMENT ACCESSIBLE.INSALLÉ À PROXIMITÉ DU MATÉRIEL ET DOIT ÊTRE AISÉMENT ACCESSIBLE.
FOR CONTINUED PROTECTION AGAINST RISK OF FIRE, REPLACE ONLY WITH SAME TYPEFOR CONTINUED PROTECTION AGAINST RISK OF FIRE, REPLACE ONLY WITH SAME TYPE
AND RATING OF FUSE.AND RATING OF FUSE.
POUR NE PAS COMPROMETTRE LA PROTECTION CONTRE LEPOUR NE PAS COMPROMETTRE LA PROTECTION CONTRE LES RISQUES D’INCENDIE,S RISQUES D’INCENDIE,
REMPLACER PAR UN FUSIBLE DE MÊME TYPE ET REMPLACER PAR UN FUSIBLE DE MÊME TYPE ET DE MÊME CARACTÉRISTIQUESDE MÊME CARACTÉRISTIQUES
NOMINALES.NOMINALES.