Digi SM-5300 - System Information and Checksum

S M - 5 3 0 0 S e r v i c e M a n u a lS M - 5 3 0 0 S e r v i c e M a n u a l || 9797


Hardware Test And MaintenanceHardware Test And Maintenance
––––––––––––––––––––––––––––––––––––––
7.6 Write AD Checksum
7.6 Write AD Checksum
7.6 Write AD Checksum7.6 Write AD Checksum
Note:Note:
1)1)
Ensure the Span Switch is set to “Ensure the Span Switch is set to “EnableEnable”.”.

2) This procedure will done when 2) This procedure will done when the scale replacement a new the scale replacement a new AD board.AD board.
Procedure Picture
Procedure Picture
1) 1) In In Registration Registration mode, mode, press press and and follow follow byby
key button go to MENUkey button go to MENU


[MAINTENANCE][MAINTENANCE]



[MAINTENANCE][MAINTENANCE]



[SCALE][SCALE]
to go to DATABASEto go to DATABASE
mode.mode.
2) At Scale menu, select2) At Scale menu, select [WRITE CHECKSUM][WRITE CHECKSUM]..
3) Keying the Password or Enable the 3) Keying the Password or Enable the Span Switch,Span Switch,
then touchthen touch [CONFIRM][CONFIRM]button.button.
4) Waiting for write 4) Waiting for write checksum in process.checksum in process.