Digital Projection E-Vision 7500 Series - SERVICE menu

Digital Projection E-Vision 7500 Series A TOUR OF THE MENUS Operating Guide
52
Rev D July 2014
SERVICE menu
Information
• The rst part of the menu is for information only.
Blue Only
• Set this to On or Off as required.
Factory Reset
• The projector will ask for conrmation before restoring all settings to
factory defaults.
• When the conrmation box appears, use or to move the
blue highlight to OK or Cancel, then press ENTER to conrm your
selection.
INPUT
PICTURE LAMPS
ALIGNMENT
CONTROL
SERVICE
Model : DP-9670-SDPHB
Serial Number : C202XXXXY0008
Software Version : MD04-0D01-LD06-RE04-SE02-PD03-9B03
Active Source : HDMI
Pixel Clock : 148.65 MHz
Signal Format : 1080p/50Hz
H/V Refresh Rate : H: 56.306 kHz V: 50Hz
Lamp 1 Time : 44 HRS
Lamp 2 Time : 45 HRS
Power On Time : 45 HRS
Blue Only < Off >
Factory Reset Enter
Notes
See also Using the Menus, earlier
in this guide and Menu Map, later in
this guide.
Do NOT do this unless you are
sure that you want to restore ALL
settings to their factory defaults.
Confirm
OK Cancel