Digital Projection E-Vision 7500 Series - ALIGNMENT Menu; CONTROL Menu

Digital Projection E-Vision 7500 Series THE OPERATION COMMANDS Remote Communications Guide
65
Rev D July 2014
...continued from previous page
<operation> <command> <values> Notes
ALIGNMENT menu
proj.mode = ? 0 = Front
1 = Rear
2 = Ceiling + Front
3 = Ceiling + Rear
Not applicable in STANDBY mode.
fan.pos = ? 0 = Normal
1 = Up
2 = Down
Not applicable in STANDBY mode.
zoomio + - + = Zoom out
- = Zoom in
Motor command. Not applicable in STANDBY
mode.
focus + - + = Focus Near
- = Focus Far
Motor command. Not applicable in STANDBY
mode.
vert.offset + - + = Up
- = Down
Vertical Lens Shift
Motor command. Not applicable in STANDBY
mode.
horiz.offset + - + = Right
- = Left
Horizontal Lens Shift
Motor command. Not applicable in STANDBY
mode.
lens.load = 1 ~ 10 Lens Memory Load
Not applicable in STANDBY mode.
lens.save = 1 ~ 10 Lens Memory Save
Not applicable in STANDBY mode.
lens.center (execute) Not applicable in STANDBY mode.
v.keystone = ? + - -80 ~ +80 Not applicable in STANDBY mode.
CONTROL menu
eco.net.pow = ? 0 = Off (Standard Standby Mode)
1 = On (ECO Standby Mode)
Eco Network Power
auto.powoff = ? 0 = Off
1 = On
Not applicable in STANDBY mode.
auto.powon = ? 0 = Off
1 = On
continued on next page...
Notes