Digital Projection E-Vision 7500 Series - The Operation Commands

Digital Projection E-Vision 7500 Series THE OPERATION COMMANDS Remote Communications Guide
60
Rev D July 2014
The Operation Commands
<operation> <command> <values> Notes
INPUT menu
input.sel = ? 0 = HDMI
1 = DVI
2 = VGA
3 = Component / BNC
4 = DP
Not applicable in STANDBY mode or when Picture
Mute is On.
pattern = ? 0 = Color Bar
1 = Cross Hatch
2 = Burst
3 = Red (TI)
4 = Green (TI)
5 = Blue (TI)
6 = WHITE (TI)
7 = BLACK (TI)
8 = HRamp (TI)
9 = Red (uncorrected)
10 = Green (uncorrected)
11 = Blue (uncorrected)
12 = White (uncorrected)
13 = Black (uncorrected)
14 = Off
Not applicable in STANDBY mode.
color.space = ? 0 = Auto
1 = YCbCr (Rec. 601)
2 = YPbPr (Rec. 709)
3 = RGB-PC (0-255)
4 = RGB-Video (16-235)
Not applicable in STANDBY mode or without signal
locked.
input.lock = ? 0 = Auto
1 = 48 Hz
2 = 50 Hz
3 = 60 Hz
Not applicable in STANDBY mode or without signal
locked.
no.signal = ? 0 = Logo
1 = Blue
2 = Black
3 = White
Not applicable in STANDBY mode.
continued on next page...
Notes