Operating The Projector
Switching the projector on
1. Connect the power cable between the mains supply and the projector. Switch on at the switch next to the power connector.
2. Wait until the self-test has completed and the Power indicator on the projector control panel shows red. The lamp will be off and the
projector will be in STANDBY mode.
3. Press POWER on the control panel or POWER ON on the remote control.
The Power indicator on the control panel will ash green for a few seconds whilst the lamp comes up to full brightness. When the
projector is ready for use, the Power indicator will show steady green.
Selecting an input signal or test pattern
Input signal
1. Connect an image source to the projector. The signal should be automatically detected by the projector, and should be displayed within
two or three seconds.
2. If more than one signal is connected, select the input you want to display:
• Press INPUT repeatedly on the control panel or remote control to cycle through the inputs.
• or use Input Selection in the INPUT menu.
Test pattern
If you do not have an image source connected to the projector, you can display a test pattern instead:
• Press TEST PATTERN repeatedly on the remote control to cycle through the test patterns,
• or select a Test Pattern from the INPUT menu.
Notes
For full details of how to connect an
image source to the projector, see
the Connection Guide.
For full details of how to use the
controls and the menu system, see
the Operating Guide.
To return to viewing the image from
your image source, scroll through
the test pattern list to Off.
To Next Page
Loading...
Need help?
General
