Digital Projection E-Vision 7500 Series - Error Codes

Digital Projection E-Vision 7500 Series THE OPERATION COMMANDS Remote Communications Guide
67
Rev D July 2014
...continued from previous page
<operation> <command> <values> Notes
SERVICE menu
model ? <string>
ser.no ? <string>
sw.ver ? <string>
pixel.clock ? <string> In MHz
Not applicable in STANDBY mode or without signal
locked.
signal ? <string> Not applicable in STANDBY mode or without signal
locked.
h.refresh ? <string> Not applicable in STANDBY mode or without signal
locked.
v.refresh ? <string> Not applicable in STANDBY mode or without signal
locked.
lamp1.hours ? <string>
lamp2.hours ? <string>
proj.runtime ? <string>
blue.only = ? 0 = Off
1 = On
fact.reset (execute) Factory reset
Miscellaneous commands
power.on (execute) Power on
power.off (execute) Power off (puts projector into Standby mode)
status ? 0 = standby
1 = warm up
2 = imaging
3 = cooling
4 = reset
errcode ? <string> Returns an error code - refer to the Error Codes
section below.
Notes