Digital Projection E-Vision 7500 Series - PICTURE Menu Continued; Overscan; VGA Setup Submenu; Auto Sync

Digital Projection E-Vision 7500 Series A TOUR OF THE MENUS Operating Guide
43
Rev D July 2014
PICTURE menu continued
Overscan
• Set this to Off, On or Zoom as required.
VGA Setup submenu
• Press ENTER to open the VGA Setup submenu.
H Total, H Start, H Phase, V Start
• Adjust the sliders for these settings, as required to suit the incoming
image.
Auto Sync
• Press ENTER to force the projector to re-synchronise with the input
signal.
Notes
Overscan is used to compensate
for noisy or badly dened image
edges, by cropping the image, or
increasing the size of the image to
force the edges off screen.
You can also press the AUTO SYNC
button on the remote control or
control panel to re-synchronise the
image.
See also Using the Menus, earlier
in this guide and Menu Map, later in
this guide.
INPUT
PICTURE
LAMPS ALIGNMENT CONTROL SERVICE
Picture Mode < High Bright >
Contrast < 100 >
Brightness < 100 >
Saturation < 100 >
Hue < 100 >
Gamma < Video >
Color Enter
Sharpness < 0 >
Noise Reduction < 0 >
Aspect Ratio < Letterbox >
Overscan < Off >
VGA Setup Enter
Autosync Execute
VGA Setup
H Total < 100 >
H Start < 100 >
H Phase < 100 >
V Start < 100 >