Digital Projection E-Vision 7500 Series - LAMPS Menu

Digital Projection E-Vision 7500 Series THE OPERATION COMMANDS Remote Communications Guide
64
Rev D July 2014
...continued from previous page
<operation> <command> <values> Notes
hsg.g.hue = ? + - 0 ~ 200 Not applicable in STANDBY mode or without signal
locked.
hsg.b.hue = ? + - 0 ~ 200 Not applicable in STANDBY mode or without signal
locked.
hsg.c.hue = ? + - 0 ~ 200 Not applicable in STANDBY mode or without signal
locked.
hsg.m.hue = ? + - 0 ~ 200 Not applicable in STANDBY mode or without signal
locked.
hsg.y.hue = ? + - 0 ~ 200 Not applicable in STANDBY mode or without signal
locked.
hsg.wr.gain = ? + - 0 ~ 200 Not applicable in STANDBY mode or without signal
locked.
hsg.wg.gain = ? + - 0 ~ 200 Not applicable in STANDBY mode or without signal
locked.
hsg.wb.gain = ? + - 0 ~ 200 Not applicable in STANDBY mode or without signal
locked.
LAMPS menu
lamps = ? 0 = Dual
1 = Lamp1
2 = Lamp2
3 = Single
Not applicable in STANDBY mode or when lamp is
cooling.
lamp.mode = ? 0 = Standard
1 = Economy
2 = Custom Power Level
Drive
Not applicable in STANDBY mode or without signal
locked.
lamp.pwr = ? 0-31 (75 % ~100.0 %) Not applicable in STANDBY mode or without signal
locked.
altitude = ? 0 = Off
1 = On
High Altitude
Not applicable in STANDBY mode.
lamp1.stat ? 0 = Off
1 = On
Not applicable in STANDBY mode.
lamp2.stat ? 0 = Off
1 = On
Not applicable in STANDBY mode.
continued on next page...
Notes