Menu Map
Menu Submenus and Controls
INPUT
Input Selection HDMI, DVI, VGA, Component/BNC, Display Port, HDBaseT
Test Pattern Color Bar, Crosshatch, Burst, Red, Green, Blue, White, Black, H Ramp, Uncorrected Red, Uncorrected
Green, Uncorrected Blue, Uncorrected White, Uncorrected Black, Off
Color Space Auto, YCbCr, YPbPr, RGB-PC, RGB-Video
Input Lock Auto, 48Hz, 50Hz, 60Hz
Background Logo, Blue, Black, White
Auto Sync Adjust Always, Off, Auto
PICTURE
Picture Mode High Bright, Presentation, Video
Contrast slider, 0 to 200 (100)
Brightness slider, 0 to 200 (100)
Saturation slider, 0 to 200 (100)
Hue slider, 0 to 200 (100)
Gamma Video, Linear, Film, Graphics
Color
Color Temperature Native, 5000K, 6500K, 7800K, 9300K
Trim Red Lift, Green Lift, Blue Lift, Red Gain, Green Gain, Blue Gain: sliders, 0 to 200 (100)
Hue Red, Green, Blue, Cyan, Magenta, Yellow: sliders, 0 to 200 (100)
Saturation Red, Green, Blue, Cyan, Magenta, Yellow: sliders, 0 to 200 (100)
Gain Red, Green, Blue, Cyan, Magenta, Yellow: sliders, 0 to 200 (100)
White Balance Red, Green, Blue: sliders, 0 to 200 (100)
Sharpness slider, 0 to 31 (0)
Noise Reduction slider, 0 to 15 (0)
Aspect Ratio 5:4, 4:3, 16:10, 16:9, 1.88, 2.35, Letterbox, Native, Unscaled
Overscan Off, Crop, Zoom
VGA Setup H Total, H Start, H Phase, V Start: sliders, 0 to 200 (100)
Auto Sync Press ENTER to execute
Notes
Some of the information in this menu
map is summarised. See the actual
menu on the projector for full detail.
Some menu options and controls
may not be available due to settings
in other menus. These will be
shaded grey on the actual menu.
Where it would be helpful, some
menu options are described in more
detail earlier in this operating guide.
Color Temperature values depend
on other settings.
To Next Page
Loading...
Need help?
General
