Digital Projection E-Vision 7500 Series - Changing the Filters

Digital Projection E-Vision 7500 Series CHANGING THE LENS, LAMPS, FILTERS AND COLOR WHEEL Installation and Quick-Start Guide
10
Rev D July 2014
Changing the lters
1. Press the air lter covers, then pull them out as shown in Fig. 1.
2. Pull out the old lters as shown in Fig. 2.
3. Insert the new lters and close the lter covers as shown in Fig. 3.
Notes
The projector will shut down if any
of the covers are opened whilst in
operation.
The lters should be changed at the
same time as the lamp is changed.
Fig. 1
Fig. 2
Fig. 3