Digital Projection Titan Super Quad Series - Image Menu; Video Filters; VGA Setup

Digital Projection Titan Quad & Titan 800 Series A TOUR OF THE MENUS Operating Guide
Op 8
Rev F November 2012
Image menu
• Brightness, Contrast, Gamma, Hue and Saturation
Set the slider or select from the drop-down list as required, to improve the quality of the image.
• Black Level Offset
Set this to 0 IRE or 7.5 IRE as required.
Video Filters
Set the sliders or select from the drop-down list as required, to improve the quality of the image.
VGA Setup
• Set the Phase slider to correct for shimmering or poor quality denition on, for example, ne text.
• Set the Total H Samples slider to match the resolution of the incoming video signal,
or Use Auto Setup to allow the projector to detect the appropriate settings automatically.
Notes
Main Menu
Image
You can also press , or
on the remote control.
Hue applies only to NTSC signals.
When a new input mode is detected
(eg NTSC, HDTV 1080p, SVGA etc),
all the Input Settings are saved so
that they can be recalled next time
that input mode is displayed.
Main Menu
Image
Video Filters
Main Menu
Image
VGA Setup
VGA Setup is not available unless
a VGA signal is present.