InputConguration
This menu allows adjustment of various technical parameters specic to each of the signal inputs,
regardless of which input is being used.
• DVI Boost EQ should normally be set to Off, except when you are having problems with a long DVI
cable.
• DVI / HDMI Color Space should normally be set to Auto, except when the projector has problems
identifying the correct colour space.
• DVI / HDMI Range should normally be set to Auto, except when you are having contrast problems
with some DVI sources.
• Set DVI-I Port to choose between the Analog and Digital signals from a DVI-I source.
• DVI Main Operation
Select between single and dual link DVI reception.
• DVI Main Range
Select between Full and Limited range.
• Set Component Colour Space to choose between RGB and YPbPr.
• Component Sync Type should be set to Auto, except when the projector has problems selecting between 3 Wire (RGsB) and 4 Wire
(RGBS).
• If two video streams are being transmitted, use 3G-SDI Level B Stream to choose between the two streams.
Notes
Main Menu
Setup
InputConguration
To Next Page
Loading...
Need help?
General
