Digital Projection Titan Super Quad Series - System

Digital Projection Titan Quad & Titan 800 Series A TOUR OF THE MENUS Operating Guide
Op 21
Rev F November 2012
System
• Conguration: switch between PIP and Edge Blend.
The other settings in this menu are provided mainly to allow control from the Web Conguration Utility.
• Use the Shutter Open and Shutter Close commands as required.
• Use the Power Off command to set the projector into Standby mode.
Notes
Main Menu
Setup
System
When you switch between PIP
and Edge Blend, the projector will
reboot instantly to enable the new
setting.
The Power On command has no
function when seen on the projector
OSD.
However, it can be used from
the Web Conguration Utility
described at the end of this guide.
Both the keypad and remote control
have dedicated buttons allowing
access to the
Shutter Open,
Shutter Close, Power On and
Power Off commands.