3D menu
• Set 3D Enable to On or Off as required.
• Use the Frame Rate Multiplier to reduce icker when the incoming 3D video signal has a low
frame rate.
For example, a 48Hz frame rate could be tripled to 144Hz.
• 3D Type should be set to Auto, except when the projector has problems selecting between
Sequential, Frame Packing, Top and Bottom and Side by Side (Half).
• Set the Dark Time to reduce the ghosting that can be caused by the images overlapping whilst
the glasses are switching.
• Set the Sync Offset to compensate for signal processing delays in the projector.
• Set the Output Sync Polarity to suit the glasses, or if the left and right images appear to be
swapped.
• Set Source Dominance to Left or Right to suit the incoming 3D video signal.
L
R
Frame Packing
L
R
Top-and-Bottom
L R
Side-by-Side (Half)
L R L R
Sequential
Notes
Main Menu
3D
Set the Dark Time to the value
appropriate to the glasses or
ZScreen.
Adjust the Sync Offset to eliminate
ghosting and achieve a smooth
grayscale.
For additional information on 3D
settings, see the Reference Guide.
The information on this page does
not apply to 2D projectors.
To Next Page
Loading...
Need help?
General
