Digital Projection Titan Super Quad Series User Guide

Digital Projection Titan Quad & Titan 800 Series MENU MAP Operating Guide
Op 28
Rev F November 2012
Main Menu Sub Menus
Setup
Orientation Desktop Front, Desktop Rear, Ceiling Front, Ceiling Rear
Latency Lowest, Best Video
Input Conguration
DVI Boost EQ Off, On
DVI / HDMI Color Space RGB, YPbPr, Auto
DVI / HDMI Range Full, Limited, Auto
DVI-I Port Digital, Analog
DVI Main / SubOperation Single Link A, Single Link B, Dual Link
DVI Main / Sub Range Full, Limited
Component Color Space RGB, YPbPr
Component Sync Type 3 Wire, 4 Wire, Auto
3G-SDI Level B Stream Stream 1, Stream 2
Network
DHCP Off, On
IP Address (numeric input)
Subnet (numeric input)
Information: DHCP Status, IP Address, Subnet, MAC Address
On Screen Display
Language US English, UK English
Timeout 5 sec, 10 Sec, 15 sec, 20 sec, 25 sec, 30 sec, innite
Position Center, Top Left, Top Right, Bottom Left, Bottom Right
Messaging Off, On
System
Conguration PIP, Edge Blend
Shutter Open (command)
Shutter Close (command)
Power On (command)
Power Off (command)
Reset Default Settings (command)
Notes
Some of the information in this menu
map is summarised. See the actual
menu on the projector for full detail.
The underlined text represents
the factory default value for each
setting.
Do NOT reset the settings unless
you are sure that you want to restore
ALL the current settings to their
factory defaults.

Digital Projection Titan Super Quad Series Specifications

General

Brand	Digital Projection
Model	Titan Super Quad Series
Category	Projector
Language	English