dji MATRICE 350 RTK

MATRICE 350 RTK User Manual
©
2023 DJI All Rights Reserved.
103
1. Control the gimbal, adjust the camera zoom and aim at the target, and tap to capture a
photo directly or press the C1 on the remote controller to set a waypoint. The waypoint and
photo quantity will increase accordingly.
2. The number of planned waypoints.
2
1
4
3
map. Drag to adjust its position. After a POI is added, the aircraft yaw can be set as facing the
POI so that the aircraft nose points at the POI point during the mission. Tap this icon again
to disable the POI function.
5. Flight Route Information: displays the ight length, estimated ight time, waypoint quantity,
photo quantity.
6. Set Individual Waypoints: select a waypoint and set its parameters. Tap “<” or “>” to switch
to the previous or next waypoint. The settings are applied to the selected waypoint, including
aircraft speed, aircraft altitude, aircraft yaw mode, waypoint type, aircraft rotation, gimbal
tilt, waypoint actions, longitude and latitude.
7. Parameters List: edit the route name, advance ight route settings and altitude mode, and
set the aircraft type.
8. Route Settings: the settings are applied to the entire route, including safe takeo altitude,
ascend to start point, aircraft speed, aircraft altitude, aircraft yaw, gimbal control, waypoint
type, and completion action. These parameters will take eect for all waypoints in the route.
On how to set the relevant parameters for the waypoints individually, please refer to the
next description.
9. Save: tap to save the flight route. After the flight route is saved, the icon becomes the
perform task button, tap the button and then check the settings and status of the aircraft
in the pop-up checklist. Tap to upload the ight route. Once the upload is complete, tap the
Start button to perform the current task.
Mission Flight - Live Mission Recording
Tap Create a Route, Waypoint Flight, and Live Mission Recording to record information on the
photos captured or aircraft position for the waypoint.