dji MATRICE 350 RTK

MATRICE 350 RTK User Manual
88
©
2023 DJI All Rights Reserved.
Gimbal Camera View
Using Gimbal Camera View
Gimbal camera view will appear when you switch the main view to the gimbal camera. Below is
an illustration using the zoom camera as the main view.
1. Navigation Display: refer to the Navigation Display section for details. Note that in gimbal
camera view, the horizontal speed, wind speed, gimbal pitch angle and pitch scale, and
the inclination of the gimbal relative to the ground are shown on the left side. When the
gimbal is at a key angle such as -90°, 0°, or -45°, the number will be highlighted. The right
side of Navigation Display shows the altitude, relative altitude, vertical obstacle sensing
information, and vertical speed bar.
2. Camera Type: displays the camera type for the current main view.
3. Camera Parameters: displays the camera’s current shoot/record parameters.
4. Auto Exposure Lock: tap to lock the current exposure value.
5. Focus Mode: tap to switch the focus mode, between MF (manual focus), AFC (continuous
autofocus) and AFS (single autofocus).
6. Storage Mode: displays the remaining photo number or the video duration video of the
microSD card. Tap to check the remaining capacity of the storage and select the storage
format.
7. Switch to Auto/Manual Exposure: the zoom camera supports Auto and M modes. The EV
can be set in Auto mode, and the ISO and shutter can be set in M mode.
8. Camera Settings: tap to enter the camera setting menu. The camera setting menu may vary
by camera type. Select a camera type to view its parameters.
9. Photo/Video toggle: tap to switch between photo and video modes, and select dierent
shooting or recording modes.
10
11
1
2 3 4 5 6 7
8
9
12
13
14
15
1617
18
19
20
21
22
23
24 25 26