dji MATRICE 350 RTK

MATRICE 350 RTK User Manual
32
©
2023 DJI All Rights Reserved.
Emergency Propeller Stop
The Combination Stick Command (CSC) can be used to execute the emergency propeller stop
once the ight controller detects critical error during ight.
Flight Test
Takeo/Landing Procedures
1. Place the aircraft in an open, at area with the battery level indicators facing towards you.
2. Turn on the remote controller, then turn on the aircraft.
3. Launch DJI Pilot 2 and enter the Camera View.
4. Wait until the Aircraft Status Indicators blink green.
5. If the Intelligent Flight Battery temperature is low, use the self-heating function to heat the
batteries to ensure the temperature is suitable for the aircraft to take o.
6. Turn on the motors using CSC and push the throttle stick up slowly to take o.
7. To land, hover over a level surface and gently pull down on the left stick to descend.
8. After landing, hold the throttle stick at its lowest position until the motors stop.
9. Turn o the aircraft rst, then the remote controller.
• Watch our video tutorials for more ight information.
Post-Flight Checklist
1. Perform visual inspection to make sure that the aircraft, remote controller, gimbal camera,
Intelligent Flight Batteries, and propellers are in good condition. Contact DJI Support if there
are any damages.
2. Make sure that the camera lens and vision system sensors are clean.
3. Make sure to store aircraft correctly before transporting it.
DJI AirSense
Airplanes with an ADS-B transceiver will actively broadcast ight information including locations,
ight paths, speeds, and altitudes. DJI aircraft incorporated with the DJI AirSense technology
are capable of receiving ight information broadcast from ADS-B transceivers that comply with
1090ES or UAT standards within a radius range of 10 kilometers. Based on the received ight
information, DJI AirSense can analyze and obtain the location, altitude, orientation, and velocity
of the surrounding manned airplanes, and compare such figures with the current position,
altitude, orientation, and velocity of the DJI aircraft to calculate in real time the potential risk
of collision with the surrounding manned airplanes. DJI AirSense will then display a warning
message in DJI Pilot 2 according to the risk level.