dji MATRICE 350 RTK - In-Flight Editing

MATRICE 350 RTK User Manual
©
2023 DJI All Rights Reserved.
105
In-Flight Editing
Enter the mission library, select a created ight route for editing or viewing.
1. Tap to view the Library.
2. Select a ight route to preview.
3. Tap to view the ight route settings.
4. Tap to edit the ight route.
1
3
4
Fly with caution1
2
• AI Spot-check can only be used with the H20 series payload in zoom camera view.
• AI Spot-check takes photos at up to 10 times the focal length.
• RTK should be used for photo capture and Planned Route ight of the AI Spot-check,
and the RTK base station coordinates of the photo capture and Planned Route ight
must be the same.
• AI Spot-check can support up to 750 photos.
• The ratio of the selection box size of the photo to the area of the whole photo cannot
be less than 1/25 when using AI Spot-check.
• The selection box position must be in the middle of the view and the size needs to be
the same as the target size.
• If Advanced Dual Operator Mode is in use, Controller A must be used to complete the
Demo Flight and mission upload.
• H20 and H20T gimbal and camera should be installed on the 1st gimbal port.