dji MATRICE 350 RTK

MATRICE 350 RTK User Manual
54
©
2023 DJI All Rights Reserved.
Any voice prompts and alerts will be disabled in Mute mode, including alerts during RTH and
low battery alerts for the remote controller or aircraft. Use with caution.
Charging the Remote Controller and Checking the Battery Level
Charging the Remote Controller
1. Connect the BS65 Intelligent Battery Station to a power outlet using the AC power cable, and
press the power button once to power on the battery station.
2. Connect the battery station and the remote controller USB-C ports using a USB-C to USB-C
cable.
3. The battery level LEDs start to flash to indicate that the Internal battery is activated and
charging started.
4. It takes approximately 2 hours to fully charge the remote controller internal battery.
• It is recommended to use the DJI BS65 Battery Station for charging. Otherwise, use a
certied USB-C charger with a maximum rated power of 65 W and maximum voltage
of 20 V such as the DJI 65W Portable Charger.
• Fully discharge and charge the remote controller every three months. The battery
depletes when stored for an extended period.
• If a WB37 battery is installed in the remote controller, the WB37 battery will be
charged at the same time. The WB37 battery can also be charged by inserting to the
BS65 battery station.
• The remote controller cannot be powered on before activating the internal battery.
The internal battery of the remote controller can also be activated after mounting the
WB37 battery.
• Make sure to use the included USB-C to USB-C cable for optimal charging.
Charging Options
A. The internal battery of the remote controller can be charged with a charging device or
the inserted external WB37 battery. It takes approximately two hours to fully charge the
internal battery with a charging device. The internal battery can be charged up to 50% with
the external battery. Charging with the external battery is not possible after the remote
controller is powered o.