dji MATRICE 350 RTK

MATRICE 350 RTK User Manual
42
©
2023 DJI All Rights Reserved.
IP Rating
Under stable laboratory conditions, the M350 RTK achieves an IP55 protection rating by
IEC60529 standards when equipped with TB65 Intelligent Flight Batteries. However, this
protection rating is not permanent and may reduce over time after long-term use.
• DO NOT y when the amount of rainfall exceeds 100 mm / 24 h.
• Make sure the battery ports, battery compartment ports, battery surfaces, and battery
compartment surfaces are dry before inserting the batteries.
• Make sure the battery ports and battery surfaces are free from any liquid before charging
the batteries.
• Before packing the aircraft into the carrying case, ensure that it is free from any liquid by
wiping it carefully.
• Product warranty does not cover water damage.
The aircraft does not achieve IP55 protection rating in the following circumstances:
• You use batteries other than the M350 RTK's TB65 Intelligent Flight Batteries.
• The cover for the ports are not attached correctly.
• The waterproong top shell plug is not rmly attached to the top shell.
• The aircraft is broken due to various reasons, such as broken aircraft shell, failure of the
waterproof adhesive, etc.
Expansion Ports
The three payload ports and one E-Port located on the top and bottom of the aircraft support
SDK, enabling more feature development. Visit https://developer.dji.com/ for more information
about SDK development.
• The three payload ports and the E-Port of M350 RTK support PSDK development.
Payload port development requires Skyport/X-Port accessories, and the power supply
is 17.0 V/4 A and 13.6 V/4 A. The power supply of E-Port is 24 V/4 A. The total power of
the four ports is limited to 180W.
E-Port Payload Port
Payload Ports