dji MATRICE 350 RTK

MATRICE 350 RTK User Manual
©
2023 DJI All Rights Reserved.
81
• It is recommended to carefully conduct the preight check according to the operation
scenario and requirements before takeo.
• Before executing a mission flight, conduct a preflight check and verify the basic
parameter information of the mission flight. Refer to the Mission Flight section for
details.
FPV Camera View
Using FPV Camera View
After tapping Enter Camera View on the homepage of DJI Pilot 2 and finishing the preflight
check, you will be directed to FPV camera view by default.
1. Top Bar: displays the aircraft status, flight mode, signal quality, etc. Refer to the Top Bar
section for more details.
2. Discreet Mode Switch: tap to turn off the aircraft rear indicators and front indicators,
beacons, auxiliary light, and battery indicators. After enabling Discreet Mode, the auxiliary
light will not turn on during landing, which may present certain risks. Use Discreet Mode with
caution.
3. Beacons Switch: press the L1 button on the remote controller to turn the beacons on or o.
4. Switch to Map View: press the L3 button on the remote controller to switch to map view.
5. Map View: Users can maximize or minimize the map. The map view supports zooming in
and out.
6. Gimbal Camera View: tap to switch to gimbal camera view. The gimbal camera view
supports zooming in and out.
7. Switch to Gimbal Camera View: press the R3 button on the remote controller to switch to
1
2
3
4
5 6 78
9
Fly with caution1