dji MATRICE 350 RTK

MATRICE 350 RTK User Manual
110
©
2023 DJI All Rights Reserved.
Oine Update
An offline firmware package can be downloaded from the DJI official website to an external
storage device such as a microSD card or U disk. Run DJI Pilot 2, tap HMS, and then Firmware
Update. Tap Oine Update to select the rmware package of the remote controller, aircraft, or
battery station from the external storage device and tap Update All to update.
Using DJI Assistant 2 (Enterprise Series)
DJI Assistant 2 (Enterprise Series) supports the updating of the aircraft, remote controller and
the Zenmuse H20/H20T gimbal cameras but not the BS65 battery station and the Zenmuse
H20N/L1/P1 gimbal cameras.
Aircraft and Remote Controller
1. Connect the remote controller or aircraft to the PC one by one, as the DJI Assistant 2 does
not support the updating of multiple DJI devices at the same time.
2. Make sure the PC is connected to the internet and the DJI device is powered on with a
battery level higher than 25%.
3. Run the DJI Assistant 2, log in with your DJI account and enter the main interface.
4. Tap the rmware update button on the left side of the main interface.
5. Select the firmware version and tap to update. The assistant software will download and
update the rmware automatically.
6. When the “Update successful” prompt appears, the device update is completed, and the DJI
device will restart automatically.
H20 series Firmware Update
1. Install the H20 series payload onto the aircraft. Power on the aircraft. Connect the aircraft to
a PC with a Type-C USB cable.
2. Run the DJI Assistant 2. Click the corresponding device name and then the H20 series
rmware update tag.
3. Select the firmware version required. Make sure to connect to the Internet when
downloading the rmware. Restart the device after the rmware update is complete.
• CSM Radar rmware updates are included with aircraft rmware updates.
• The battery firmware is included in the aircraft firmware. Be sure to update the
rmware of all batteries.
• The rmware of the Zenmuse H20N/L1/P1 cannot be updated using DJI Assistant 2. If
the rmware of the aircraft is updated using DJI Assistant 2 while the Zenmuse H20N/
L1/P1 is attached, only the aircraft rmware will be updated. Use an SD card or DJI
Pilot 2 to update the rmware of Zenmuse H20N/L1/P1.
• Make sure all DJI devices are connected properly to the PC during an update.