dji MATRICE 350 RTK

MATRICE 350 RTK User Manual
©
2023 DJI All Rights Reserved.
75
Battery Maintenance
Capacity Calibration
1. Follow the steps to complete capacity calibration when prompted to do so by DJI Pilot 2.
Charge to 100% Rest for 1 hour Discharge to below
20%
Rest for 1 hour
Battery Maintenance
1. Battery performance will be aected if the battery is not used for an extended period.
2. Perform battery maintenance once every 50 cycles or 3 months or when prompted to do so
by DJI Pilot 2, in the following steps:
Charge to 100% Rest for 24 hours Discharge to below 20% Rest for 1 hour
Charge the battery fully or to the proper power level for storage after completing battery
maintenance. Contact DJI Support if a maintenance failure persists.
In addition to the above, we recommend conducting the following checks for battery
maintenance:
a. Insert the battery into the aircraft and power it on to view the battery information in DJI
Pilot 2. Make sure the dierence in cell voltage is less than 0.1 V and the battery rmware is
updated to the latest version.
b. Make sure the battery is not swollen, leaky, or damaged.
c. Make sure the battery terminals are clean.
d. Regularly check the battery level and battery cycle counts. The battery is rated for 400 cycles.
It is not recommended to continue to use afterward.