dji MATRICE 350 RTK

MATRICE 350 RTK User Manual
56
©
2023 DJI All Rights Reserved.
Linking the Remote Controller and Control Stick Modes
Linking the Remote Controller
The remote controller is already linked to the aircraft when it is purchased together as part of
a combo. Otherwise, follow the steps below to link the remote controller and the aircraft after
activation.
Method 1: Using Combination Buttons
1. Power on the remote controller and the aircraft.
2. Press the C1, C2, and Record buttons simultaneously until the status LED blinks blue and the
remote controller beeps twice.
3. Press and hold the power button on the aircraft for at least five seconds. The aircraft
power indicator will blink and will beep twice to indicate linking has started. When linking is
successful, the aircraft status indicators will blink green while the remote controller will beep
twice, and the remote controller status LEDs will turn solid green.
Method 2: Using DJI Pilot 2
1. Power on the aircraft and the remote controller.
2. Run DJI Pilot 2 and tap Link Remote Controller to link. The status LED of the remote
controller will blink blue, and the remote controller will beep during linking.
3. Press and hold the power button on the aircraft for at least five seconds. The aircraft
power indicator will blink and will beep twice to indicate linking has started. When linking is
successful, the aircraft status indicators will blink green while the remote controller will beep
twice, and the remote controller status LEDs will turn solid green.
• Make sure the remote controller is within 50 cm (1.6 ft) of the aircraft during linking.
• Make sure the remote controller is connected to the internet when logging in using a
DJI account.
New database for safty available
Prepare To Fly
Academy
Prohibited areas
Limit fly
Fire Rescue
Traffic Police Brigade
Academy
Album
Album
Air Line
Remote Controller Linking
5s