dji MATRICE 350 RTK

MATRICE 350 RTK User Manual
30
©
2023 DJI All Rights Reserved.
Calibrating the Compass
Only calibrate the compass when prompted to do so by the DJI Pilot 2 app or the aircraft status
indicators. Observe the following rules when calibrating the compass.
• DO NOT calibrate the compass in locations with strong magnetic interference, such
as near magnets, parking lots, or construction sites with underground reinforced
concrete structures.
• DO NOT carry ferromagnetic materials such as mobile phones during calibration.
• The DJI Pilot 2 app will display a prompt if the compass is affected by strong
interference after calibration is complete. Follow the displayed instructions to resolve
the compass issue.
Calibration Procedure
Perform the calibration in an open area and follow the steps below to complete the calibration.
1. Run the DJI Pilot 2 app and enter camera view on the homepage. Tap and tap , then
go to Sensor Status, Compass, and Calibrate Compass to start the calibration. The aircraft
rear indicators will glow in solid yellow, which indicates that the calibration has started.
2. Rotate the aircraft 360 degrees. The aircraft rear indicators will glow in solid green.
3. Hold the aircraft vertically with the nose pointing downward, and rotate the aircraft 360
degrees around the center axis.