dji MATRICE 350 RTK

MATRICE 350 RTK User Manual
92
©
2023 DJI All Rights Reserved.
1. Palette/Isotherm: displays the highest and lowest temperature measurement values of
the current view. Tap to choose between different infrared temperature measurement
palettes, or enable the isotherm to set temperature measurement intervals. Note that if the
measured area exceeds the maximum or minimum temperature measurement values of the
current view, the setting will not take eect.
2. Gain Modes: high gain mode provides more accurate temperature measurements with a
measurement range from -20° to 150 ° C, while low gain mode supports a wider temperature
measurement range of 0° to 500° C. Note that the range is only a theoretical value, and even
though the thermal camera can measure temperatures beyond the range, the value may
deviate substantially.
3. Display Mode: the infrared screen is set as single infrared view by default. Tap to enable or
disable side-by-side view. When enabled, both the footage captured by the infrared thermal
camera and the zoom camera will be displayed side by side.
4. FFC Calibration: tap to execute FFC calibration. FFC calibration is a function of the infrared
thermal camera that optimizes image quality for easy observation of temperature changes.
5. Zoom (Thermal Camera): tap to adjust the digital zoom of the infrared thermal camera with
a maximum zoom capability of 20x. Tap and hold to zoom directly to 2x.
Laser Rangender (RNG)
1. Tap to enable the RNG.
2. The cross hair in the center of the lens will turn red, which means the laser rangefinder
is aiming at the target and measuring the altitude of the target and distance between the
target and the aircraft. The latitude and the longitude of the target can be obtained after a
PinPoint is created on the target.
3. The linear distance between the target and the aircraft.
4. The altitude between the target and the aircraft.
FPV
1
2
3
4
5
6