dji MATRICE 350 RTK

MATRICE 350 RTK User Manual
©
2023 DJI All Rights Reserved.
109
Firmware Update
Use DJI Pilot 2 or DJI Assistant 2 (Enterprise Series) to update the remote controller, aircraft and
other connected DJI devices.
Using DJI Pilot 2
Aircraft and Remote Controller Firmware Updating
1. Power on the aircraft and remote controller. Ensure the aircraft is properly linked to the
remote controller, their battery levels are higher than 25%, and the remote controller is
connected to the internet.
2. Run DJI Pilot 2. A prompt will appear on the homepage if new rmware is available. Tap to
enter the Firmware Update view.
3. Tap Update All and DJI Pilot 2 will download the rmware and update the aircraft and remote
controller.
4. The aircraft and remote controller will automatically restart after the firmware update is
completed.
• The update takes approximately 15 minutes (depending on network strength). Make
sure the remote controller is connected to the internet during the whole update
process.
• The TB65 intelligent ight batteries, DJI CSM Radar and gimbal camera installed on the
aircraft will be updated to the latest rmware version.
Battery Station and TB65 Batteries
Use the DJI Pilot 2 app to update the rmware of the battery station as well as up to eight TB65
ight batteries at the same time.
1. Insert the TB65 batteries into the battery port and power on the battery station.
2. Connect the battery station USB-C maintenance port to the remote controller USB-C port
using a USB-C cable.
3. Power on the remote controller and make sure it is connected to the internet.
4. Run DJI Pilot 2. If a version update is available, the homepage will prompt that the battery
station rmware update is required. Tap to enter the battery station update page.
5. Tap the Update All button to begin the update, which takes approximately 10 minutes. The
update is completed when the update success prompt appears.
• During a rmware update, DO NOT insert or remove the batteries to avoid battery
update failure.
• During a rmware update, DO NOT unplug the USB-C cable to avoid rmware update
failure.