dji MATRICE 350 RTK

MATRICE 350 RTK User Manual
©
2023 DJI All Rights Reserved.
97
Annotation Management and Synchronization
PinPoint
Introduction to PinPoint
PinPoint is available when using the H20 series gimbal camera. PinPoint can be used to set
the location point of a target in gimbal camera view or map view, for quick observation and
information synchronization.
1. Steps to Create a PinPoint: adjust the attitude of the aircraft and the gimbal to move the
target to the center of the current view. Press the L3 button of the remote controller to pin
the target at the center. The PinPoint can record the latitude, longitude and altitude of the
target.
2. AR projection will be created for the target in gimbal camera view or FPV camera view. It will
become larger or smaller according to the distance between the aircraft and the PinPoint (big
when near, small when far).
3. Selected PinPoint:
a. A small frame will appear around the PinPoint indicating it is selected.
b. The lower left corner of Navigation Display shows the horizontal distance from the target
to the aircraft and the name of the point. The orientation of the point relative to the
aircraft is shown within Navigation Display.
c. If the selected PinPoint is outside the video transmission view, the PinPoint icon will stay
on the edge indicating the its orientation relative to the center of the view.
d. After selecting a PinPoint, the user can edit the name, color, latitude, longitude, and
altitude of the target point, or drag the PinPoint on the map.
4. Tap and tap to change the custom remote controller settings to PinPoint, delete the
1
2
3
4
5
Fly with caution1