MATRICE 350 RTK
User Manual
©
2023 DJI All Rights Reserved.
67
13. WB37 Battery Level LEDs
14. USB-C Maintenance Port
15. Power Button
16. Battery Station LED
17. Charging Mode Switch
18. Charging Mode LEDs
1. Connect the battery station to a power outlet using a AC power cable.
2. Press the power button once to power on the battery station.
3. Charging the TB65 batteries:
a. Align the orange marks on the TB65 battery and the battery port, then insert the batteries
into the battery ports.
b. Toggle the charging mode switch to Storage Mode, Ready-to-Fly Mode, or Standard Mode.
Storage Mode : each battery pair is charged to 50% in sequence and kept at 50% after
charging. Storage Mode is good for long-term battery storage.
Ready-to-Fly Mode : each battery pair is charged to 90% in sequence and kept at 90%
after charging. Ready-to-Fly Mode facilitates quick use of batteries.
Standard Mode : each battery pair is charged to 100% in sequence.
c. The battery station will charge the batteries in pairs. The pair with the highest power will
be charged rst.
4. Charging the WB37 batteries: insert the WB37 batteries, and the battery with the highest
battery level will be charged rst.
5. Charging the DJI RC Plus remote controller: connect the remote controller to the USB-C
charging port using a USB-C to USB-C cable.
• The battery station should stay powered on to maintain the battery level in Storage
Mode and Ready- to-Fly Mode. Maintaining a high power level in Ready-to-Fly Mode
will aect battery life. Power o the battery station after charging, except for special
situations such as re emergencies.
• Connect the remote controller to the maintenance port and run DJI Pilot 2 to view
battery information, update the rmware, or diagnose the error.
• When the temperature of the TB65 battery is below 18° C (64.4° F), the batteries will be
automatically warmed up after being inserted into battery station and powered on.
Using the Battery Station
Charging
To Next Page
Loading...
