dji MATRICE 350 RTK

MATRICE 350 RTK User Manual
©
2023 DJI All Rights Reserved.
73
Checking Battery Level
Press the battery level button to check the current battery level when the power supply is o.
After turning on the power, check the current battery level in the top bar of the app.
The Battery Level Indicators will also show the current battery level during discharging.
The indicators are dened below.
: LED is on. : LED is o. : LED is ashing.
LED1 LED2 LED3 LED4 Battery Level
88%~100%
75%~87%
63%~74%
50%~63%
38%~49%
25%~37%
13%~24%
0%~12%
Hot Battery Replacement
After landing, the aircraft does not have to be powered o for replacement of its batteries. First,
insert a fully charged battery and wait for three seconds before inserting another battery.
Warming the Battery
Manual Heating: if the Intelligent Flight Battery is not installed into the aircraft, press and hold
the battery level button on the battery for four seconds to initiate the self-heating, keeping the
batteries at a temperature between 16° C (61° F) and 20° C (68° F), which is the ideal range of
operating temperature, for approximately 30 minutes. Press and hold the battery level button
for two seconds to stop heating.
Auto Heating: insert the batteries into the aircraft and power it on. If a low battery temperature
is detected, the battery will automatically heat up to maintain a temperature between 16° C (61° F)
and 20° C (68° F).
• The performance of the intelligent Flight Battery is signicantly reduced when ying in
low temperature environments (temperatures below 5° C). Ensure that the battery is
fully charged before each ight.