dji MATRICE 350 RTK

MATRICE 350 RTK User Manual
96
©
2023 DJI All Rights Reserved.
Map View
1. Tap to draw lines on the map.
2. Tap to draw an area on the map.
3. Tap to clear all points, lines, and annotations on the current view. If the user is logged in on
DJI FlightHub 2, the icon is not shown.
4. PinPoint: press the L1 button on the remote controller to add a PinPoint in the center of the
view. Press and hold on the L1 button to expand the PinPoint settings panel, which allows
users to change the PinPoint color, view all target points, or set the default display of the
target point in video transmission view.
5. Switch to FPV Camera View: press the L3 button on the remote controller to switch to FPV
camera view.
6. Switch to Gimbal Camera View: press the R3 button on the remote controller to switch to
gimbal camera view.
7. Tap to clear the ight track of the aircraft.
8. Map Layer Selection: tap to select a satellite or street map (standard mode) according to
operation requirements.
9. Map Lock: if enabled, the map cannot be rotated; if disabled, the map can rotate freely.
10. Recenter Button: tap to quickly center the remote controller in the view.
11. GEO Zone Layer Management: tap to view all GEO Zone layer information and enable or
disable the GEO Zone layer.
1
2
3
4
5
6
7
8
9
10
11