dji MATRICE 350 RTK - Page 68

MATRICE 350 RTK User Manual
68
©
2023 DJI All Rights Reserved.
Paired Charging of Batteries
TB65 batteries should be used in pairs to extend battery life. Inserted batteries in the top
and bottom ports will be automatically paired in the sequence of A, B, C, and D. The charging
sequence is illustrated below:
• Between paired and a single battery, paired batteries will be charged rst. (Figure a)
• When there are multiple battery pairs, the pair with the highest power will be charged rst.
(Figure b)
• When none of the batteries are paired, the two batteries with the highest battery level will
be charged rst. (Figure c)
When the power of the batteries in one pair is not the same, the battery station will charge the
one with less power rst, and then charge the paired batteries together once their power is the
same.
10%
30%
30%
10% 30%
20%
40%
10% 30%
Figure a Figure b Figure c
LEDs and Buzzer Description
LED Indicators Description
Power Button
Solid green Powered on
Battery LEDs
Blinks green Charging
Solid green Charging completed
Blinks yellow Warming up/Cooling down
Solid yellow Waiting to charge
Blinks red
Battery port communication error. Reinsert the battery or try
another battery port.
Solid red & buzzer beeps Battery error*
Battery Station LED
Blinks yellow Updating battery station rmware
Solid red & buzzer beeps Battery station error*
* Connect the remote controller to the maintenance port, run DJI Pilot 2, and tap HMS to diagnose the error.