Draytek Vigor2925 Series - Page 20

Vigor2925 Series User’s Guide
4
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
WAN2
Right
LED
Off The port is connected with 10/100Mbps
On The port is connected.
Off The port is disconnected.
Left
LED
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
LAN1~LAN5
(for Vigor2925)
LAN1~LAN4
(for Vigor2925F)
Right
LED
Off The port is connected with 10/100Mbps.
Switch on Rear Side (For Vigor2925L only)
Interface Description
Factory Reset Restore the default settings. Usage: Turn on the router (ACT LED is
blinking). Press the hole and keep for more than 5 seconds. When you
see the ACT LED begins to blink rapidly than usual, release the button.
Then the router will restart with the factory default configuration.
USB1~USB2 Connector for a USB device (for 3G/4G USB Modem or printer or
Environmental Thermometer).
WAN1
(for Vigor2925F)
Fiber connection (100Mbps) for accessing the Internet.
WAN1~WAN2 Connecter for local network devices or modem for accessing Internet.