Vigor2925 Series User’s Guide
618
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
i
i
p
p
6
6
i
i
n
n
t
t
e
e
r
r
n
n
e
e
t
t
This command allows you to configure settings for accessing Internet.
ip6 internet -W n -M n [-<command> <parameter> | ... ]
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
-W n
W means to set WAN interface and n means different
selections. Default is WAN1.
n=1: WAN1
n=2: WAN2
n=3: WAN3
.
.
n=X: WANx
-M n
M means to set Internet Access Mode (Mandatory) and n
means different modes (represented by 0 – 5)
n= 0: Offline,
n=1: PPP,
n=2: TSPC,
n=3: AICCU,
n=4: DHCPv6,
n=5: Static
n=6:6in4-Static
n=7:6rd
[<command>
<parameter>|…]
The available commands with parameters are listed below.
[…] means that you can type in several commands in one
line.
-m n
It means to set IPv6 MTU.
N = any value (0 means “unspecified”).
-u <username>
It means to set Username.
<username>= type a name as the username (maximum 63
characters).
-p <password>
It means to set Password.
<password> = type a password (maximum 63 characters).
-l n
It means to set IPv6 prefix length for protocol of 6rd.
n: IPv6 prefix length.
-s <server>
It means to set Tunnel Server IP.
<server>= IPv4 address or URL (maximum 63 characters).
-d <server>
It means to set the primary DNS Server IP.
<server>= type an IPv6 address for first DNS server.
-D <server>
It means to set the secondary DNS Server IP.
<server>= type an IPv6 address for second DNS server.
-t <dhcp/ra/none>
It means to set IPv6 PPP WAN test mode for DHCP or
To Next Page
Loading...
Need help?
General
