Vigor2925 Series User’s Guide
466
Available settings are explained as follows:
Item Description
Hotline
Check the box to enable it. Type in the SIP URL in the field
for dialing automatically when you pick up the phone set.
Session Timer
Check the box to enable the function. In the limited time
that you set in this field, if there is no response, the
connecting call will be closed automatically.
T.38 Fax Function
Check the box to enable T.38 fax function.
Error Correction Mode – choose a mode for error
correction.
DND (Do Not Disturb)
mode
Set a period of peace time without disturbing by VoIP
phone call. During the period, the one who dial in will listen
busy tone, yet the local user will not listen any ring tone.
Index (1-15) in Schedule - Enter the index of schedule
profiles to control when the phone will ring and when will
not according to the preconfigured schedules. Refer to
section Application >>Schedule for detailed configuration.
Index (1-60) in Phone Book - Enter the index of phone
book profiles. Refer to section DialPlan – Phone Book for
detailed configuration.
CLIR (hide caller ID)
Check this box to hide the caller ID on the display panel of
the phone set.
Call Waiting
Check this box to invoke this function. A notice sound will
appear to tell the user new phone call is waiting for your
response. Click hook flash to pick up the waiting phone
call.
Call Transfer
Check this box to invoke this function. Click hook flash to
initiate another phone call. When the phone call connection
succeeds, hang up the phone. The other two sides can
communicate, then.
Default SIP Account
You can set SIP accounts (up to six groups) on SIP Account
page. Use the drop down list to choose one of the profile
names for the accounts as the default one for this phone
setting.
Play dial tone only when account registered - Check this
box to invoke the function.
In addition, you can press the Advanced button to configure tone settings, volume gain, MISC
and DTMF mode. Advanced setting is provided for fitting the telecommunication custom for
the local area of the router installed. Wrong tone settings might cause inconvenience for users.
To set the sound pattern of the phone set, simply choose a proper region to let the system find
out the preset tone settings and caller ID type automatically. Or you can adjust tone settings
manually if you choose User Defined. TOn1, TOff1, TOn2 and TOff2 mean the cadence of the
tone pattern. TOn1 and TOn2 represent sound-on; TOff1 and TOff2 represent the sound-off.
To Next Page
Loading...
Need help?
General
