dSPACE DS1103 Hardware Installation And Configuration

Uninstalling the System ▲ ■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■
■
DS1103 Hardware Installation and Configuration March 2004
I■■■■■■■■■■■■■ ▼
156
■■■■■■■■■■■■■■■▼
How to Remove the Hardware
The boards to be removed from your host PC depend on the
installation of the DS1103 PPC Controller Board:
■ If the DS1103 is installed in the host PC, the dSPACE board must
be removed from the host PC.
■ If the DS1103 is installed in an expansion box connected to the
host PC via a bus interface, the link boards (DS813/DS817) must
be removed. The DS815 can simply be ejected from the host PC.
■ DS1103 is installed in an expansion box connected to the host PC
via Ethernet, only the network cable of the expansion box needs
to be disconnected from the PC or the local area network.
Preconditions ■ The system is switched off. For instructions, refer to How to Switch
Off a dSPACE System on page 39.
■ Precautions are taken to avoid damage by high electrostatic
voltages. For details, refer to Safety Precautions for Installing and
Connecting the Hardware on page 20.
Method To remove dSPACE boards
C
WARNING! Hazardous voltages.
Risk of electric shock and/or damage to the hardware.
Before removing any board, make sure that:
■ The power supply of the host PC and/or the expansion box are
switched off.
■ No external device is connected to the dSPACE system.
1 Disconnect the host PC, the expansion box and all external devices
connected to them from the power supply.
2 Unplug any external devices or connector panels from the I/O
connectors of the DS1103.
3 Open the enclosure.

dSPACE DS1103 Specifications

General

Brand	dSPACE
Model	DS1103
Category	Controller
Language	English