dSPACE DS1103 Hardware Installation And Configuration

■
■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■ ▼ Connecting an Expansion Box to the Host PC
DS1103 Hardware Installation and Configuration March 2004
57
▲ ■■■■■■■■■■I
▲■■■■■■■■■■■■■■■
4 Switch on the system. Refer to How to Switch On a dSPACE System
on page 76.
How to Establish the
DS815 <–> DS814 Bus Interface
The following instructions apply if you want to install a bus connection
with link boards DS815 and DS814.
Cables Use only the cables which come with the hardware package.
■ DS815 Link Boards (PC) delivered before November 2001 are
equipped with other connectors. You need a matching link cable.
For details, refer to DS815 Connector and PC Card Link Cables on
page 58.
■ To connect the DS815 with a standard patch cable an adapter
cable is available from dSPACE. For details, refer to DS815-RJ45
adapter cable on page 60.
Preconditions ■ The system is switched off. For instructions, refer to How to Switch
Off a dSPACE System on page 71.
■ A DS815 is inserted in your host PC.
■ A DS814 is installed in your expansion box.
Method To establish the DS815
↔ DS814 bus interface
1 Attach the connector of the DS815 to the DS814 Link Board (Box)
with the crossed-over patch cable.
N
Do not connect the crossed-over patch cable to an Ethernet LAN or
the LAN connectors of a PC or a notebook.
2 Switch on the system. Refer to How to Switch On a dSPACE System
on page 76.

dSPACE DS1103 Specifications

General

Brand	dSPACE
Model	DS1103
Category	Controller
Language	English