dSPACE DS1103 Hardware Installation And Configuration

■
■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■ ▼ Configuring the System
DS1103 Hardware Installation and Configuration March 2004
103
▲ ■■■■■■■■■■I
▲■■■■■■■■■■■■■■■
Configuring the DS1103 PPC
Controller Board
If you have used the Plug & Play mode when installing the
DS1103 PPC Controller Board (see Setting up the DS1103 on
page 36), the board has been configured automatically. No further
configuration is necessary. When starting ControlDesk’s Platform
Manager, the DS1103 PPC Controller Board is displayed in the
Navigator in the top left of the main window. The system is ready to
run real-time applications on the board.
Setting the connection
mode and registering
the board
If you have changed the factory-adjusted I/O base address – that is, the
Plug & Play mode is disabled – you have to
■ set the connection mode – see below –, and
■ register the DS1103 using the Platform Manager – see How to
Register a DS1103 on page 106.
How to Set the Connection Mode
dSPACE real-time boards can be connected to the host via a bus
interface or via Ethernet. The type of connection selectable via
ControlDesk must suit your installation. The Platform Navigator shows
only the boards that are connected and registered.
Connection modes The Change Connection dialog is used to select the desired
connection mode. The following table shows which connection mode
you have to specify:
dSPACE System Installed ... Required Connection Mode
... in the host PC Bus connection
... in the expansion box, and connected
via Link Boards, e.g., the DS815/DS814
Bus connection
... in the expansion box, and connected
via Ethernet
Network connection

dSPACE DS1103 Specifications

General

Brand	dSPACE
Model	DS1103
Category	Controller
Language	English