dSPACE DS1103 Hardware Installation And Configuration

■■
■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■ ▼ Using the AutoBoot Option
DS1103 Hardware Installation and Configuration March 2004
145
▲ ■■■■■■■■■■I
▲■■■■■■■■■■■■■■■
Components of the AutoBoot
Package
The hardware and software required by Autoboot Option is provided
by the AutoBoot package.
N
For information on the necessary steps for migration from the
Autoboot environment of former dSPACE Releases (up to dSPACE
Release 3.4) to the new Autoboot environment shipped since dSPACE
Release 3.5, refer to:
%DSPACE_ROOT%\AbxBoot\Migration\MIGRATION.TXT
Hardware provided by
the AutoBoot package
The AutoBoot package contains the following hardware components:
■ One PC card reader. The PC card reader package consists of the
board itself and documentation.
■ One CompactFlash card (SanDisk 128 MB,
Model SDCFB-128-101-00).
N
It is recommended to use a SanDisk CompactFlash card, Model
SDCFB-128-101-00, for proper function. CompactFlash cards from
other manufacturers or cards with a different memory size may
also work, but were not tested by dSPACE.
■ One PC Card adapter (to be a synonym for PCMCIA-adapter) for
CompactFlash cards to be inserted in the PC card reader installed
in the expansion box.
Software provided by
the AutoBoot package
The AutoBoot package contains the following software components:
■ Loader software to load an application to the dSPACE system. The
following dSPACE systems are currently supported by Autoboot
Option: DS1103, DS1005.
■ A template file (
autoboot.bat ) to be copied to the
CompactFlash card. This file is required by the slot CPU installed in
the expansion box.

dSPACE DS1103 Specifications

General

Brand	dSPACE
Model	DS1103
Category	Controller
Language	English