Setting Up an Ethernet Connection Between PC and Expansion Box
▲
■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■
DS1103 Hardware Installation and Configuration March 2004
I■■■■■■■■■■■■■
▼
78
■■■■■■■■■■■■■■■▼
How to Integrate the Expansion Box into
a Network
(Windows NT 4.0)
The following instructions show how to integrate an expansion box
into an existing network step-by-step:
1. A peer-to-peer connection is needed temporarily to change the IP
address of the expansion box. Refer to How to Set Up a Peer-to-
Peer Connection (Windows NT 4.0) on page 75.
2. The IP address of the expansion box must be changed to comply
with the IP addresses used in the network. Refer to How to
Change the IP Address of the Expansion Box (Windows NT 4.0) on
page 79.
3. After you have changed the IP address of the expansion box, you
can restore the previous IP address of the host PC. Refer to How to
Restore the TCP/IP Configuration of the PC (Windows NT 4.0) on
page 80.
4. Finish the work with How to Connect the Expansion Box to the
Network and Test the Connection (Windows NT 4.0) on page 81.
To Next Page
Loading...
Need help?
General
