2 Installation
2.2 Mounting the expansion unit
Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com 25
Figure 14:Connecting remote expansion module
DANGER
The two-wire or multiple-wire cable between the devices must
adhere to the insulation voltage requirement which is stipulated
for the installation environment. Otherwise, a fault (ground fault,
short-circuit) may lead to the destruction of the units or injury to
persons.
A cable, such as NYM-0 with a rated operational voltage
U
e
= 300/500 V AC, is normally sufficient.
￫
Terminals E+ and E– of the EASY200-EASY are protected
against short-circuits and polarity reversal. Functionality is only
ensured if E+ is connected with E+ and E– with E–.
E+ E–
E+ E–
To Next Page
Loading...
