2 Installation
2.2 Mounting the expansion unit
24 Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com
Figure 13:Mounting + and removing + the local expansion module
on the easy800 device
Specific system information is shown in the status display of the easy800
standard (e.g. DC, AC or GW) depending on the expansion unit that is
connected and ready for operation.
Remote expansion module
With remote expansion, you connect the expansion unit via a connecting
cable to the EASY200-EASY coupling unit, which itself is fitted on the
easy800 standard directly via the easyLink terminal. A two-wire or multi-core
connecting cable up to 30 m in length can be used.
To Next Page
Loading...
