Eaton easy800

12 Appendix
12.9 Contacts and Coils
374 Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com
Enable counter
CF X EN - X = 01–04
Lower setpoint value undershot (Fall below) - CF X FB/CF X FB
Upper setpoint value exceeded (overflow)
CF X OF/CF X OF
Actual value equal to zero
CF X ZE/CF X ZE
High-speed counters
169
Direction
CH X D_ - X = 01–04
Enable counter CH X EN
Reset count value
CH X RE
Set counter value (Preset)
CH X SE
Actual value has exceeded counter range (carry)
- CH X CY/CH X CY
Lower setpoint value undershot (Fall below)
CH X FB/CH X FB
Upper setpoint value exceeded (overflow)
CH X OF/CH X OF
Actual value equal to zero
CH X ZE/CH X ZE
Incremental counter
174
Enable counter
CI X EN - X = 01–02
Reset count value CI X RE
Set counter value (Preset)
CI X SE
Actual value has exceeded counter range (carry)
- CI X CY/CI X CY
Lower setpoint value undershot (Fall below)
CI X FB/CI X FB
Upper setpoint value exceeded (overflow)
CI X OF/CI X OF
Actual value equal to zero
CI X ZE/CI X ZE
Comparator, for variables / constants
179
Equal to
- CP X EQ/CP X EQ X = 01–32
Greater than CP X GT/CP X GT
Less than
CP X LT/CP X LT
Text output
181
Enable
D X EN - X = 01–32
Active
- D X Q1/D X Q1
Data function block
185
Transfer 32-bit value (trigger)
DB X T_ - X = 01–32
Block is active - DB X Q1/DB X Q1
PID controller
187
Activate D component
DC X ED - X = 01–32
Activate I component DC X EI
Enable
DC X EN
Activate P component
DC X EP
Accept manual manipulated variable
DC X SE
Value range manipulated variable exceeded
- DC X LI/DC X LI
Contact
Coil
(* = NET-ID 1-8)
Contact
N/O - N/C
(* = NET-ID 1-8)
Number Page