Eaton easy800

12 Appendix
12.9 Contacts and Coils
Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com 375
Signal smoothing filter
192
Enable
FT X EN - X = 01–32
Get value from NET (GET) 196
New transferred value present
- GT X Q1/GT X Q1 X = 01–32
7-day time switch 198
Switch on condition fulfilled
- HW X Q1/HW X Q1 X = 01–32
Year time switch 203
Switch on condition fulfilled
- HY X Q1/HY X Q1 X = 01–32
Conditional jump 211
Enable
JC X EN - X = 01–32
Fault: No corresponding jump label present or backward jump - JC X E1/JC X E1
Jump Label (LaBel)
Passive jump destination for JC
213
Value scaling
214
Enable
LS X EN LS X EN X = 01–32
Master reset
218
Activate (trigger)
MR X T_ - X = 01–32
Set all outputs and markers to zero state - MR X Q1/MR X Q1
Data multiplexer (easy800 and MFD-CP10...)
220
Enable
MX X EN - X = 01–32
Fault: Incorrect parameter setting, 0 > K > 7 - MX X E1/MX X E1
Numerical converter
223
Enable
NC X EN - X = 01–32
Operating hours counter 227
Enable
OT X EN - X = 01–04
Reset OT X RE
Value overflow (carry)
- OT X CY/OT X CY
Set time reached
OT X Q1/OT X Q1
Pulse output
228
Enable
PO X EN - X = 01, 02
Start positioning job PO X S_
Activate jog mode
PO X TP
Positioning job active
PO X BR
Positioning job active
- PO X AC/PO X AC
Fault: Incorrect parameter setting, FO < FS or PF < FS.
PO X E1/PO X E1
Put value on NET (PUT)
235
Activate (trigger)
PT X T_ - X = 01-32
Enable active - PT X Q1/PT X Q1
Pulse width modulation
237
Contact
Coil
(* = NET-ID 1-8)
Contact
N/O - N/C
(* = NET-ID 1-8)
Number Page